This is the output from the “Testing Settings” window of VisualGDB.

I guessed, that I have to connect the debuging-side with the target-side with some kind of cable or plug. You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long. I was able to successfully flash a program to the board using that software. LCPXpresso is an IDE that supports debugging and it comes with an USB-Debug-Board that has a target (a C) integrated on the right side of the PCB. I was concerned that there might be something wrong with my dev board so I downloaded the Energia IDE and that worked fine. ST has the ST-LINK JTAG/SWD probe on their cheap demo board, and TI has the ICDI on their cheap demo board. I’ve selected the correct part in the device selection page but when I get to the debug method page I’m unable to proceed any further because no matter what settings I try OpenOCD fails to initialize debugging. for both STM32 and TI Stellaris in the past. Everything works fine when I use a EK-TM4C123GXL and that’s great but my project needs to have Ethernet so I’m trying to follow the same steps to get the EK-TM4C1294XL LaunchPad working. I just installed VisualGDB and I’m following the tutorial for the EK-TM4C123GXL LaunchPad. The ICDI board can also be used stand-alone, for other boards and chips than the kit it came with.

Luminary micro icdi board drivers